Solid State Logic Duality 82S6DUA20C User Manual download pdf (Page 44)

Communications

A group of communications buttons (talkback etc.) are fitted below the central routing

panel (see below). A built-in talkback microphone and pots to set the level of TB to

Foldback, Talkback Out (an external talkback feed), Slate level (talkback to Main

Mix, Track bus and channel outputs) and an incoming Listen mic, are provided in the

‘Comms” section above the DAW control TFT screen (see right).

Note that a gain control for the talkback mic preamp is provided on the connector

panel adjacent to the external talkback output jack. If required, an external talkback

mic may be connected to the console’s talkback distribution circuitry via an XLR on

the connector panel. When using this facility, turn the console mic preamp gain fully

anticlockwise (off) if you no longer wish the inboard mic to contribute to the talkback

system.

Note also that, apart from SLATE, which cuts the monitors, all the following functions dim the monitors. All the

buttons, apart from LISTEN and RED LIGHT, are momentary.

SLATE – Interrupts the Main Mix and Track bus outputs with talkback.

F/B A and F/B B – Adds talkback to the associated foldback outputs after

the level and cut controls.

EXT T/B – Sends talkback to an external feed, available via a 6.35mm jack

on the connector panel. Level is adjusted using the Talkback Out pot (see

above).

TB ALL feeds talkback to the foldback sends and the external talkback output.

LISTEN – Injects an external mic signal (connected via an XLR on the centre section connector panel) onto

whichever Mini loudspeaker set is currently active, and dims the main loudspeakers. This button is latching; the

level is adjusted using the Listen pot (see above). The mic is usually placed in the recording area. The circuitry

features SSL’s legendary listen mic compressor, the sound of which is much loved by many experienced SSL

users, so the connector panel provides a post compressor output jack – ‘Listen Mic Out’.

RED LIGHT – this provides an all-important isolated contact closure for hooking up to a studio red light via an

external relay box.

The talkback button functions are all duplicated on a Talkback/GPIO connector on the rear of the console,

as are the monitor CUT and DIM switches. See the Duality Installation Manual for more information.

RED

LIGHT

SLATE

LISTEN

EXT

T/B

F/B A

ALL

F/B B

COMMUNICATIONS

Listen

∞

TB to Foldback

∞

Slate

∞

Talkback Out

∞

Console Operator’s Guide

2-32

Duality Operator’s Manual

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 126 127

Comments to this Manuals

No comments

Solid State Logic Duality 82S6DUA20C User Manual Page 44

Comments to this Manuals